Are any of the 3D prints you’ve been doing your design? Either way the skull looks great! I’ve been following your stuff both on the forum and YT for a year or two abouts, I don’t think I’ve commented on anything of yours yet though, so I’ll say it now, the detail of your props is incredible. As is the way you continue to tweak things until you’re satisfied, I wish I had half your talent.

 

Nothing I've 3d printed is of my own design. I have not yet learned to do any 3d modeling so I depend on what others have uploaded to sites like Thingiverse for anything I print. I do modify some prints after they are printed though, such as replacing the teeth on this skull with acrylics for a more realistic look and modifying the way the spine assembles on the skull and spine print I did. Thanks for the kind words!

 

Well done! What prevents the skull from sliding to the bottom of the pole?

 

Just a screw into the pipe. The opening underneath is sized just right that about 1/4" of screw sticking out will keep it from sliding down further.

 

The detail on this is great and will make the entrance gate have a little creepier flare to it.
As always, I am looking forward to seeing it in October.