Halloween Forum banner
1 - 2 of 2 Posts

1,403 Posts
Discussion Starter · #1 ·
Hi all,

Ok, I've been looking at dmx stuff today and I know one site is offering the 3-axis at dmx option. I've read a very small portion of what I should know but, what is the difference besides movement? Do you need special servo's or boards? I take it that it plugs right into the dmx512. So how would it plug into the servo board? I haven't seen any boards to run the servo's. Where would I purchase the material to build a dmx 3-axis?

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.