Halloween Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
228 Posts
Discussion Starter · #1 ·
Has anyone used wireless DMX control with VSA? I was wondering if this will work thus replacing DMX cable runs from computer to prop.
 

·
Registered
Joined
·
30 Posts
I don't use VSA, but I control my haunt from a lighting console. I use wireless DMX to go from the console to several of my fixtures and then usually run cables from those to other fixtures as needed. Depending on your setup, a wireless system should work for you just fine, they are just expensive.
 

·
Registered
Joined
·
228 Posts
Discussion Starter · #3 ·
I purchased one transmitter and one receiver on Amazon. So I am hoping using and entec pro DMX interface between my computer and my lighting board this will work.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top