Halloween Forum banner
Cancel

Wiper Motor Power Supplies and Connectors

1161 Views 7 Replies 5 Participants Last post by  Ghost Ninja, 
Ghost Ninja
Hello all, I need to order a new power supply and I came across at least two different sizes. Fright Props lists their connectors at 5.5 mm x 2.1 mm and many listed on Ebay and elsewhere are listed as 5.5 mm x 2.5 mm.


So my question is will they work interchangeably? I suppose I could cut it off and attach my own female end to match.


Second question, on Ebay I see a lot of low price power supplies that seem to be designed for printers or monitors, but they are 12v 5a. Would they work on wiper motor prop?

Thanks in advance.
Reply
Save
Like
  • Like
Reactions: 1
1 - 1 of 8 Posts
B
slicing off the existing adapter plug and attaching your own isn't the greatest of ideas. Those plugs are polarized, meaning the current always flows one particular way. The new plus you attached has to be connected the same way, or you'll likely end up frying whatever you plug it into.
Reply
Save
Like
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Halloween Forum
Halloween forum - Keeping the Halloween spirit alive 365 days a year. Discuss decorations, costumes and more!
Full Forum Listing
Explore Our Forums
General Halloween Halloween Props Member Introduction Party Ideas. Experiences and Recipes Tutorials and Step-By-Step
Top