Halloween Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
Hi, I just recently upgraded and replaced some servos that were installed on one of my animatronic figures, and now the servos are off calibration and need to be adjusted using the "Track Adjustment" feature on VSA v5. Can anybody give me an in depth explanation on how to use track adjustment with VSA. Specifically how the offset and scaling works.The VSA manual is a little vague on this certain feature. Also the servo controller that is being used on this figure is a "Parallax Propeller USB Servo Controller". Any advice would be much appreciated.
 
1 - 1 of 1 Posts
Top