Halloween Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
169 Posts
Discussion Starter #1
I ran across some posts but can't remember where - not sure if it was an email I received or a blog post or youtube video. But, for anyone that uses a dremel to create their tombstones, I wondered what bits you like using and for what purposes? Such as maybe you use a 654 bit for removing large recessed areas or maybe a 561 for carving epitaphs? I'd love to hear your recommendations!

Thanks in advance! :D
 

·
Registered
Joined
·
393 Posts
I use the 1/8 multipurpose bit #561 more than anything else. While it's smaller and takes a little while longer to do larger things, I personally feel like I have more control. That's the OCD in me. :)
 

·
Registered
Joined
·
169 Posts
Discussion Starter #5
Thank you all for the replies. Rockstar - that helps alot because my biggest issue is I can't even start doing the epitaphs out of fear of messing up the stones. So, control is absolutely what I need. Slow and steady. :)
 
1 - 6 of 6 Posts
Top