Halloween Forum banner
1 - 3 of 3 Posts

·
Blaberus craniifer
Joined
·
4,920 Posts
Discussion Starter · #1 ·
So I decided to try my hand at a singing skull using the MonsterSheild prop controller. I glued a servo to the bottom of a cheap plastic Barney skull and attached the jaw to it. I then wired it to a EFX-TEK Prop1 board and set the open and close positions. I then connected PIN7 (the trigger) to one of the relays on the MonsterShield prop controller. Then it was just a matter of key-banging (tapping) out the song lyrics.
https://youtu.be/0ZTFO-pQdzE
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top