Halloween Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
75 Posts
Discussion Starter · #1 ·
I have mounted an oversized foam skull on an armature connected to a vent motor. The assembly is inside a tombstone such that the skull extends outside the boundaries of the tombstone then retracts within. My intent is to cover the front of the tombstone with some thin, stretchy fabric and then up or side light the tombstone to highlight the effect.

So far, I have not been able to find a fabric that will stretch yet still be thin enough to all the skull details to be seen.

Any suggestions?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top