Halloween Forum banner

Static character making help

1996 Views 10 Replies 9 Participants Last post by  bradbaum
does anyone know the best way to make a non moving static character. Also one that is very cheap.
Thanks
1 - 1 of 1 Posts

· Registered
Joined
·
1,115 Posts
When I made my figures in the past, I started with a 2x4 frame. For standing figures, the boards were cemented into boots to support. Then the upper half would be PVC secured to the 2x4s, ie neck,arms,shoulder. The filler would be foam stapled to the wood and wrapped and taped around the PVC with duck tape. To support these standing in wind, you can have a board set in the ground at the back of the figure.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top