Halloween Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #2 ·
Some pictures....

Cabinet "before":


First coat monster mud:


Washes going on for depth:


Coin Door "before":


One coat of monster mud with orange/brown acrylic mixed in:


Dark orange applied over the mud:


Then 'dark earth' over that:


And finally some bright orange diluted and applied for drips/streaks:
 

·
Registered
Joined
·
42 Posts
Wow, so much detail! That's fantastic, you've really gone above and beyond. Thank you for sharing!
 

·
Registered
Joined
·
61 Posts
Discussion Starter · #6 ·
I have a new 3D printer, so I had to use that for the joystick. ;-)

This is the femur piece printed in clear SLA material:


Once the support structure is cleaned off:


Here it is with the 3D part on the joystick shaft for a test fitting:


And with the hollow 3D printed piece on the joystick shaft it's ready for molding:


Then I removed the 3D piece from the shaft and co-molded Tap Plastic urethane plastic on instead for durability:
 
1 - 7 of 7 Posts
Top