Halloween Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
I would like to show my Halloween 2018 prop I've been working on. It's a pneumatic stand up skeleton controlled by an Arduino. It's triggered by a laser trip wire, though I'm might change it back to PIR

The eyes and ribs flashing is to let me know when the program is finished, so that might change

I originally planned to have it speaking and the jaw moving but ran out of time. That's a project for next year.

Hope it gets some scares! :)

 

·
Registered
Joined
·
21 Posts
Discussion Starter #3
Thanks.

I've had a look at the controller, looks good! I might have a go at controlling the servo using a ka2284 sound level module, i've seen a few people control skull jaws on YouTube using one. I already use a ka2284 to control a thunder and lightning prop.

All good fun!
 
1 - 4 of 4 Posts
Top