Halloween Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
372 Posts
Discussion Starter #1
After completing my Rising Blucky, I played around to see what else I could do with the same basic set up. Most of my static props are simple PVC frames so I decided to add some arm movement. Here are a couple of pics. The trick is that I filed out two opposite ends of a 1" PVC cross so that a 1" PVC pipe could slip through with almost no friction. Hooked up a air vent motor (I love those things) and that was that. Once I set the range of motion for the arm, I'll drill through the elbow connecting the arm to the pivot and install a pin. This guy is gonna be a butcher chopping severed limbs on a counter.



Here's a short clip.
YouTube - IMG 0052
 

·
Registered
Joined
·
496 Posts
THis would be good for a grave digger waving a kerosene lamp - on my list...thanks for sharing.

Dennis
 

·
Registered
Joined
·
298 Posts
Very Cool! I can't wait to see the completed prop!!! Keep us informed!
 

·
Registered
Joined
·
372 Posts
Discussion Starter #4
Here's a clip of the finished prop, ready to take center stage in Dracula's Pub.

And no he won't need any pants as the lower half will be out of sight.

 
1 - 5 of 5 Posts
Top