Halloween Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
326 Posts
Discussion Starter #6
Well the head form is one from Amazon. I basically then just measure and cut burlap, also from Amazon. I have tried many different glues but 3m spray adhesive works the best. To harden it I use water base polyurethane, satin finish. The paints are simple 50 cent paints from Wal-Mart. The final step is an oil based poly to make it water proof.
 

·
Registered
Joined
·
326 Posts
Discussion Starter #7
Oh, and the head form is not enough so I tape a mask over the head form. Under there is a dinosaur mask, others work just as well.
 

·
Registered
Joined
·
326 Posts
Discussion Starter #9
Here is attempt number two, the initial molding done. Hopefully I learned from the first one and will make an even better one.

DSCN1494.jpg
 
1 - 12 of 12 Posts
Top