Halloween Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
rgb eyes.jpg USBSSCa.jpg

Hi to all happy Halloween
I am trying to use some RGB lights to this controller it's a DF Robot SSC 32 it says to put it in relay mode put I don't see how you do this l don't want to do something wrong

and what do they mean by low pin & high pin state?

Any help would be appreciated
Thanks Bob
 

·
Registered
Joined
·
3,625 Posts
Can't read the diagram but "low state" means the pin is connected to GND. "High state" means the pin is positive voltage.
 

·
Registered
Joined
·
3,625 Posts
Yeah, your LED's are connected to constant positive voltage via the center pins, when your "pulse" pin is high, the LED will be off. When the "pulse" pin is low, LED will be on.
 
1 - 7 of 7 Posts
Top