Halloween Forum banner
1 - 20 of 26 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Hey all. I wanted to share this Halloween prop I finished. I'm calling it a pumpkin lamp, but not sure that's good nomenclature or not. Everything was sculpted in Zbrush. I then 3D printed all parts. It stands at about 4' tall. I'm pretty happy with how it came out, and will probably be making a few more to round out my yard.
Plant Leaf Wood Grass Trunk
Pumpkin Jack-o'-lantern Cucurbita Winter squash Calabaza

Plant Calabaza Branch Wood Tree

Plant Jack-o'-lantern Fire Tree Pumpkin
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #7 ·
Hey now that's pretty cool! (y)

How does it stand freely on it's own? Is it somewhat hollow and you can stick something like rebar in the ground and slide your lamp/tree limb/stump over it?

I took one of those ground hangars that you use for strawberry plants, cut the top half off, and then I printed a sleeve that slides over it and used some expanding foam to set it inside the lower 1/3rd of the post.
 
1 - 20 of 26 Posts
Top