Halloween Forum banner

Projector- what went wrong?

1960 Views 16 Replies 11 Participants Last post by  Rabbit101
Ok busted out the projector for the first time in our new house. Has planned on shooting it from our second story into the window for passers by to see. However ran into a few issues that hopefully someone can help me with.

When I shot it through the window the image seemed to reflect back and show off the wall leaving me with the small image in the glass and a huge second one behind it on the wall. Any ideas why? I had read that just shooting it through the window should be fine.

I wound up just turning the projector around and shooting off the wall for Halloween but still want to figure out why.

Thanks in advance
1 - 1 of 1 Posts

· Registered
Joined
·
4,434 Posts
Not sure what you were trying to do. If you were trying to project the image onto the window so it appears from outside you need some type of scrim covering the inside of the window, you can't just project onto the glass.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top