Halloween Forum banner

Projector- what went wrong?

1966 Views 16 Replies 11 Participants Last post by  Rabbit101
Ok busted out the projector for the first time in our new house. Has planned on shooting it from our second story into the window for passers by to see. However ran into a few issues that hopefully someone can help me with.

When I shot it through the window the image seemed to reflect back and show off the wall leaving me with the small image in the glass and a huge second one behind it on the wall. Any ideas why? I had read that just shooting it through the window should be fine.

I wound up just turning the projector around and shooting off the wall for Halloween but still want to figure out why.

Thanks in advance
1 - 1 of 1 Posts

· Registered
87 Posts
I use a Shear White Chiffon (Same stuff as a prom dress) purchased at Joann Fabric it hangs wrinkle free and shows the image on both sides.
I staple a 1 X 2" stick to the top edge and to the bottom edge which pulls it flat
Its more expensive than a white shower curtain but I can reuse every year without folding up a plastic shower curtain and dealing with the wrinkles every year.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.