Halloween Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter #1
I've been wanting to make one of these for a while now. It would be great for our living room (not that the Casket(s) don't get enough attention). It's not done as of yet, I'm letting the stain dry before moving forward. I pulled a lot of photos from the net to try and get it accurate, but in the end it's just a chair with wires. Next step is the electronics. It will have a fog machine, vibrating sander and strobe light effects added. IMG_20140629_193628546.jpg IMG_20140629_193642452.jpg IMG_20140629_193812740.jpg IMG_20140629_082745199.jpg
 

·
Registered
Joined
·
53 Posts
Discussion Starter #6
Working on the control board now. The gauges I got from ebay. I made the knife switch as I could not find one I liked. I'll have a 6" red rotating beacon mounted to the board that will go off when armed. Lookin good so far.
 

Attachments

1 - 7 of 7 Posts
Top