Halloween Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
166 Posts
Discussion Starter #1
So got a bag of bones at the drugstore for 5$ instead of 12$ so I had to get it for sure.

The only thing the casting is not the best and has a big seems running on the skull and was wondering if there a cheap an easy way to smooth it out so it looks better.


image2.jpg
image1.jpg
image3.jpg
 

·
Registered
Joined
·
1,329 Posts
Fine grit sandpaper should do it, but go slowly and carefully, since the material is not exactly the most rugged stuff around. I used fine grit sandpaper on some styrofoam heads and it worked great.
 

·
Soccer and Lacrosse Dad
Joined
·
1,780 Posts
I would be inclined to use a sharp blade if you have a steady hand. A sharp blade should slice easily through the plastic seams. As mentioned you will end of with a lighter coloured seam once you peel off the layer that has been painted a little.

Which drugstore did you pick it up at?
 

·
Registered
Joined
·
166 Posts
Discussion Starter #7
Thanks for the suggestions I might try the blade and sand paper and I will certainly end up repainting and give it a aging look to it.
 
1 - 8 of 8 Posts
Top