Halloween Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hey y'all! I recently picked up a Heads Up Harry for about $50, but it didn't work at all. I opened up the base only to find that there are 2 loose wires. I have no experience with soldering or any technical stuff like that, but I'm pretty sure this is an easy fix. Here's a picture.

 

Attachments

·
Registered
Joined
·
111 Posts
The red and black just need to touch/make good contact with those two silver tabs. Turn it on and hold the wires, touch them to the tabs and see if it works. then you'll know which goes to which (I'm sure the red is +, black is -). I learned to solder, it's fun and not hard, but if you can't then a dab of hot glue holding the wire to the tab will also work temporarily.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top