Halloween Forum banner

Gemmy Donna the Dead Board picture help

1699 1
I have a Gemmy Donna the Dead prop, where the red wire coming out of the white flex has become de-soldered. I can see that the other wires coming out of the flex are all soldered to the under side of the board. I don't suppose there is a link to a schematic anywhere or perhaps any pictures of the board? The only repair information I have come across has been on replacing the rubber ring which was on this very forum (that will be my next task :) ).

Thanks in advance,

James
1 - 2 of 2 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top