Halloween Forum banner

Fence help needed. Finials.

Static: 
2K views 7 replies 6 participants last post by  Industen 
#1 ·
I built 10 sections of PVC pipe at 8 feet per panel. The problem is I used 3/4 PVC pipe and I ordered 120 1 inch finiales. The other problem is that these were ment to slide into a 1 inch opening instead of side over the top. I can not find plastic 1 inch finials that slide over. If you use 1/2 PVC you need 3/4 finials correct. Any other suggestions? I really want to use finials.
 
#4 ·
#6 ·
Not sure if this helps or not - I don't recall the relative dimensions of my PVC tubing and finials - nor can I remember where I found the idea.

Perhaps I am aging.

I used a heat gun to soften the top of the PVC tubing then squished the finial down over it. Once the PVC hardened, the finial was lodged onto it. No glue.

Cheers,

JD
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top