Electrical transformer Help!!!!

1814 Views 12 Replies 4 Participants Last post by propmaster77, Aug 4, 2011

propmaster77

Discussion Starter · Aug 2, 2011

Hi guys im stuck! I was wondering if you have any ideas on what the make the actual electric pole out of, I was thinkin a 2x4 then cylinders in front to make it drop. then i was thinking a scrim over chicken wire to make it round! Tell me any ideas to make it drop and how tall and how to anchor it, I also don't know where to drill the hole to run the air hose and cables out of transformer down the pole. Thanks

For those of you that don't know what i'm talking about go to this and watch the video!

Austin

Save

1 - 1 of 13 Posts

The Wilmont Estate

· #6 · Aug 3, 2011

To make it break in half cut the sonotube in half. Not perfectly though. Then attach a cylinder to the top portion and then attach a smaller cylinder to the bottom portion. Time them so they both push out at the same time and there you go. Be sure to also secure the sonotube with rope from the opposite side just incase something goes wrong.

Save

1 - 1 of 13 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month