Halloween Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter · #1 ·
I have a chair where the zombie sits and is powered by a drill on a shaft. when it starts up its so violent the mask i have on it flys off. any hints on securing masks, i dont have a foam head on it as i fear that would fly off and hit someone. or does anyone have a method to secure the masks to the foam head?

thanks,
Chaos
 

·
Registered
Joined
·
854 Posts
Mix the Gorilla glue with water and it expands (some) into foam but retains most of it's glue properties. spray or brush on both your head and the inside of the mask and assemble. let it cure for a while and see what happens.....
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top