Halloween Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
373 Posts
Discussion Starter · #1 ·
I have a pressure mat which activates one of my props, but the problem is it is obvious that it is used as a trigger. So how can i disguise the mat so its not so obvious ?

thanks guys

Phil :D
 

·
Technological Terror
Joined
·
724 Posts
Depends on the location of the mat. I might suggest putting leaves or straw on top of it. Some people stick it under their welcome mats if it's place near an entrance door. Just a few suggestions, but I would look at the environment it is placed in and go from there with a cleaver disguise.
 
1 - 3 of 3 Posts
Top