Halloween Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
140 Posts
Discussion Starter #1
I have a very good quality plastic vampire skull that I transfored into my demon skull last year. I haven't been able to find anything to make these stick onto the skull and it's annoying me. Please help. Some of the things ive tried:
Screws (didn't look right)
Super glue
Hot glue
JB weld
Epoxy
Used a screw as a post in the skull and glusing to that with same stuff.

The adhesives just fall off the skull.
I'M about to resort to bubble gum cause I'm out of ideas
 

·
Registered
Joined
·
140 Posts
Discussion Starter #4
For some reason I never have good luck with gorilla glue....is there a trick to using it
 

·
Registered
Joined
·
476 Posts
Hmmm have you tried the 2 part epoxy putty? that usually adheres to anything.

If you use gorilla glue first off mist the area where the horns are going on the skull and the horns with water. Not a whole lot. this will help activate it. you'll have to hold them down pretty tightly in order for them to adhere right and so the foaming doesn't raise them up. that's why i don't usually use gorilla glue for this type of use. but a lot of people have had success with it this way.

Any pics so i can see what you're working with? might get a better idea.
 

·
Registered
Joined
·
1,263 Posts
2 part epoxy putty. I like Apoxie Sculpt for general use and air putty from Smooth on if weight is a factor.
 
1 - 9 of 9 Posts
Top