[LT Scare]

I like the idea, but my greatest concern would be - is it mositure / water proof?

Clearly this prop would be most impressibe in a cemetary scene. This means outside. Outside in October means dew in the grass and likely a sprinkle or two, even in So Cal. So will this prop impress for a short while then freeze up because moisture infiltrates its workings?

Gemmys are cool, but I need to amortize their cost over more than one Halloween.

 

[LT Scare]

It would be good to see the specs on whether this was addressed in the design.

If they did, it will be first. I like my numerous Gemmys, but they're always displayed under cover.

 

[LT Scare]

I found that this is not a Gemmy product.

It is designed and created by Spirit Halloween.

We all should have guessed that, looking at the picture.

Hope Spirit considered where the prop is likely to be displayed and made it moisture resistant.

I have one spirt prop ... a very early head lifter ... that is completely latex covered (except the plastic bottom - see him in the Freddy's Furnace pic in my album) and would probably work ok in an uncovered environment - if set up off the ground. The life of the latex would be shortened, but until it dried and cracked it would work ok in a cemetary - but non directly on the ground.

FWIW