Halloween Forum banner

Connecting 2 Fog Machines Together Please Help!

5865 Views 12 Replies 5 Participants Last post by  Kenpilot
Hey guys, this might be a shot in the dark but was wondering if anyone knows how to connect 2 VEI 950 Fog Machines together in Series? It doesn't say in the manual and I can't get a hold of anybody at VEI and they no longer make this model fog machine. I know you can do it cause it says you can in the manual and there is a jack for it on the back of the machine. On the back of the machine there is a 5 pin female input for the remote control/timer and then a 3 pin female jack that says "Output to Next Unit". You would think there would also be an " Input from other unit" jack on there too but there isn't. So how in the heck do you connect 2 units together? Do you use a DMX cable? A XLR cable? A special Cable? And all cables are typically male/female cables and all the jacks on the machines are Female and thus you would need a cable with 2 male ends to go between the 2 units. I would guess since the " Output to Next Unit" is an output and the remote control/timer input as an input that you would connect them using these 2 jacks, but then you would need a 3 pin male to a 5 pin male cable, and there is no such thing that I can find anywhere. My goal is to just use 1 remote/timer plugged in to the "master" fogger and have the foggers connected to where they pump out fog at the same time when the 1 remote commands them to. Any ideas??? Please help! Audio equipment Electronics Technology Electronic device Loudspeaker
See less See more
1 - 1 of 13 Posts
They do make a 3 to 5 pin adapter for DMX cables. I think that it might work for you. Last time purchased one I don't think were more than ten or fifteen dollars and for that price it might be worth your time to give it a try. Here a ebay link for one http://www.ebay.com/itm/3-Pin-Male-to-5-Pin-Female-DMX-Converter-lighting-cable-turnaround-/161962689685?hash=item25b5ba8495:g:iBQAAOSwGotWq7RL
for under 10 dollars.
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.