Halloween Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Listmates:

I would like to sculpt a skull in clay attached to the front of a funkin (a craft pumpkin), basically using the funkin in place of the base head used for most masks to make a one piece mold. Could I use the basic the process of making a two piece mold out of plaster and cast it in latex like a mask? I read somewhere that you should only cast in plaster on clay not on other materials. Except I intend to fill it with two part foam within the latex for use on a pop-up.

Thanks
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top