Halloween Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
Ok someone here has to have had this problem with the POS Chauvets. I have a 1200 that puts out fog (dense fog for like 6-7 seconds) then blinks blue for 1 min then does same thing

I know it is reading the tank as empty, its full

Already cleaned with fluid twice
Power cycled several times
pinched the tube for suction and to prime
cleaned pump
did some bypass BS holding buttom down while power cycling (Per Chauvet)

I know heater works
I know pump works

The problem is the damn tank sensor.

HOW can I fix it - a new board is $50 - a new machine is $90. WTF!
 

·
Oak Lane Cemetery
Joined
·
1,915 Posts
Cleaned the filter in the tank at the end of the tube? Mine does the exact same thing without the blinking light, but I know what the issue is. I don't have the right remote for it. Some of their machines are very specific about the remote they will use. The remote I have does not allow me to control anything on the unit, but does allow it to work on a constant cycle as you describe, which happens to be pretty close to what I want so I'm not sweating it. Might not be your issue, but it's something to look into.
 

·
Registered
Joined
·
175 Posts
Do all the above and then just throw it in the trash. I had several of these and they were all POS. They lasted a year maybe two. Spend the money and buy anything other than CHAUVET. Just my opinion.....
 
1 - 3 of 3 Posts
Top