Halloween Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
285 Posts
Discussion Starter · #1 ·
Looking for some advice prior to starting project. I am going to build a rotating wheel of death to have in my CarnEvil theme. Has anyone built one before? I am going to use a smaller motor so looking to make it light weight, something like wood frame with cardboard for the wheel. If anyone has any ideas or suggestions please let me know.
 

·
Keeper of Spider Hill
Joined
·
1,793 Posts
On your base or stand, I'd run 2 flange mount or pillow block bearings back to back several inches apart. Run the shaft for your wheel though the bearings and they will support all of the load from your wheel. Your motor should have an easy time at that point turning your wheel even if it is made from wood. :)
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top