Halloween Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,953 Posts
Discussion Starter #1
I really like the witch silhouette.
but the placement of the on/off switch was poorly conceived.
you have to take it down to turn it on and off.

So I 3d printed a post the height of the legs used to rest against the wall. (Minus the height of my push button switch)
cut off the momentary ""try me switch" and soldered my switch onto the "try me" wire.
glued the switch on the broom section.
since there is no post here there is plenty of play to gently push the broom section while still on the wall to turn on / off the lights.
 

Attachments

1 - 1 of 1 Posts
Top