Halloween Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter #1
Hello All,

I have this posted on "Request for Tutorials", but think it might be better here.

I have been looking on here for a "how to" for this, but did not see one (I am sure I missed it). Anyway, the lid is not attached at all to coffin. the entire thing is made from wood fencing, so it has some weight to it ( I believe there is a pic on my profile page). I am just trying to lift the lid on this. I normally just lay it off center from the rest of the coffin, and have fog and lights inside. I just want some type of motion for the lid. If it were lifted to a decent height, I would attach Skeleton to lid and have that lifted with lid.

Would love some ideas, open to anything you guys might think.

Thanks in advance!

Bill
 

·
Registered
Joined
·
1,003 Posts
I'm sure there's a lot of people on here that can give you advice but I actually had to modify mine. Made the coffin using a Monster Guts wiper motor and it was choppy and struggling to lift the lid. I actually ended up redoing the lid to a really thin wood to solve the problem.
 
1 - 3 of 3 Posts
Top