Halloween Forum banner

Attaching to shaft of MonsterGuts/Rex FCG motor

1030 Views 3 Replies 2 Participants Last post by  propboy
I just ordered an FCG motor from MonsterGuts (the Rex replacement one) and cannot tell how to attach anything to the shaft. I'm not using this in an FCG, but rather an animated coffin where the lid will keep moving up and down. So, I need the aluminum stock to go flat down on the shaft, not along side it like many others do via a cable clamp/U-bolt. Any ideas?
1 - 2 of 2 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.