Halloween Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·

I am new to Arduino, but are hoping to learn a bit more untill next halloween. I am trying to make a halloween prop, that will be controlled by arduino controller, and a IR sensor to trigger its effekt. I need to use a motor, to extend a kind of scissor mechanism, to make something "jump out".. And after a few seconds, slowly return. Anyone here with experience in something like that?

Michael Almli
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.