Halloween Forum banner
Cancel

Animatronic Toe Pincher help

763 Views 3 Replies 4 Participants Last post by  function12, 
R
I have all the components needed to lift the lid of my toe pincher, speed controller wiper motor and all. I just need suggestions on how I should go about lifting the lid itself. Should I build a circular type cog that drops on one side? And if so, does any one have a picture or blueprint handy to guide me in the right direction. Thanks in advance! :cool:
Reply
Save
Like
1 - 4 of 4 Posts
K
depends on how wide you want to open the lid.
need more info.
Reply
Save
Like
H
I just used 1/2 a ying yang. Bolted it to wiper motor and mounted in casket at desired height. Worked great!!!

This year I pumped it up a notch and went pneumatic. Good Luck
Reply
Save
Like
F
You can also just cut out a circle or egg shape piece of wood and mount your motor off center.
Reply
Save
Like
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Halloween Forum
Halloween forum - Keeping the Halloween spirit alive 365 days a year. Discuss decorations, costumes and more!
Full Forum Listing
Explore Our Forums
General Halloween Halloween Props Member Introduction Party Ideas. Experiences and Recipes Tutorials and Step-By-Step
Top