Halloween Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
Does anyone have knowledge of whether or not you can use the ssc32 to run led eyes and the servos for a 3axis skull? I am using vsa hobbyist, and the power supply from triaxial skull labs, and just wanted to see if this is possible or if I needed another controller of some kind.
Thanks everyone.!
 

·
Scared Silly
Joined
·
1,931 Posts
You can connect the LEDs to the servo connections on the board. If you just go into the ground and "VS1", you'll have an LED that you can switch on and off by setting the channel to relay in VSA. I figured out a way to do some dimming a while back, too:

LED dimming SSC-32 VSA.jpg

The reason it takes two channels is that I couldn't make the PWM fade down all the way, so I had to make the GND on a relay channel to be able to get it all the way off.

You'll probably need resistors.
 

·
Registered
Joined
·
39 Posts
Discussion Starter #3
Awesome, thanks. Do you know if this will work for rgb led as well? I have both and know rgb is more difficult.
 
1 - 4 of 4 Posts
Top