Pneumatic: 2 Bar Lifter
1 - 4 of 4 Posts
Joined
·
38 Posts
Looks great. and looks well built
Joined
·
2,887 Posts
That came out pretty damn good considering you didn't use a welder Daddy-O, great job!
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
Screws that will hold onto foam?
Halloween PropsI sometimes need to attach things to foam. In one instance it was a foam tombstone that I needed to attach to a thin plywood base, so it would stand up on a stage. Many years ago, I recall seeing someone use what I thought were drywall screws. But, that didn't hold at all on the polystyrene...- 15
- 460
-
Corpsing and painting
Halloween PropsI made this prop today, tried to go for the old mummy corpse look using the plastic method. Any tips to make it better?- 16
- 536
-
HillStreetHaunt · updated
-
What DMX software should I use? FOSS? Open Source? Less than $100? Bought a Chauvey Obey 70 & am ready to Rock and Roll!
Halloween PropsSo. After a few decades of home haunted, nearly dying on the Operating Table, & living in a small house on a Postage Stamp Lot here in Winter Garden, FL (#Orlando area): a 15 min drive to the Haunted Mansion @ the MK: well, to the TTC. We live so close that every so often the wife & I will take...- 2
- 174
-
Photo Op Scare Props
Halloween PropsHave you created any photo ops and incorporated scare props? we had folks taking pictures with some of our static props (crypts, Corpses, mausoleum), so I wanted to build something specifically for photo ops. I’ve seen the electric chairs that vibrate/flash when unsuspecting ToTs sit down...- 9
- 417
-
SkullHedge · updated
-
Other: Does Any one Own a Horror Dome Vampire Bat Puppet?
Halloween PropsDoes anyone own a Horror Dome Vampire Bat Puppet and, if so, does it look similar to the photo? I've heard a few less-than-stellar things about that site and I'd very much like to know.- 2
- 665
Join now to ask and comment!