These are brightly lit and have a slight flicker to them. You can do any combination of pumpkins by the way. This a picture of a set of three. This tu

Supplies needed

These are brightly lit and have a slight flicker to them. You can do any combination of pumpkins by the way. This a picture of a set of three. This tu

Trace out your design on the pumpkin while the wood burner with Exacto knife blade is heating up. Then, plunge the knife into the pumpkin and slowly d

Using the 1 1/2" hole spade bit, cut two holes near each other in the back of the pumpkins (you could also just cut out the holes). You will be p

Picture 1: On the bottom of the pumpkin, draw a large circle and mark a line through both sides so when you replace the lid, you know where it should

Picture 1: Line up that line you marked, put a bead of hot glue around the edge and quickly set the bottom of the pumpkin back in place.

Picture 2:

The ground stake may be pretty secure in the pumpkin but I don't know how hard your ground is. So, pre-make a hole in the ground where the stakes woul

These are brightly lit and have a slight flicker to them. You can do any combination of pumpkins by the way. This a picture of a set of three. This tu

Terra
Oct 11, 2009

Watch Add bookmark

There are no comments to display.