Attaching the lights -- after installing some wood trim that is wide enough to hold the lights on each side of the carriage - MysterE drilled the hole

Just showing a shot of MysterE drilling the hole for the light wiring on one side of the carriage.

Making the hearse easy to store has been at the forefront of our plan-as-we-go approach. It is about the only thing we know is essential to the buildi

This shows that same bolt from the top. Notice the washers. Also - there will be at least four of these - one at each corner of the top where it attac

Attaching the lights -- after installing some wood trim that is wide enough to hold the lights on each side of the carriage - MysterE drilled the hole

Feeding the wires form the back of the light fixture - through the hole in the wood and then screwing the fixture to the face plate.

marking where the face plate will go and where to drill the holes to attache the plate as well as the feed hole for the wires to go clear through into

TO some - these are black pipe for gas lines. TO us - hearse axles!

Attaching the lights -- after installing some wood trim that is wide enough to hold the lights on each side of the carriage - MysterE drilled the hole

HallowSusieBoo
Oct 5, 2009

Watch Add bookmark

There are no comments to display.