Does anybody know of anyone who has created cemetery entrance pillars out of those long thick cardboard tubes that construction companies use for cement footings? I was thinking of going this route instead of the popular squared pillars, but I am unsure of how to make the cardboard tubes waterproof after painting.
I thought that perhaps by using these columns it would prevent the common problem of styrofoam sheeting getting chipped and broken from kids, animals, etc.
If anyone has any ideas or suggestions it would be greatly appreciated.
They are both polymer-based paints, which means that you can do clean-up with water (no solvents needed) when they are still wet - BUT once they are dry they are a plastic polymer. It forms a flexible skin over any painted surface.
The better the coverage, the more certain it's going to be waterproof. Get EVERY SINGLE BIT OF SURFACE COVERED. Inside, outside, edges, recesses, whatever...
For the best waterproof application, use the paint without watering it down, allow to dry and finish with a sealant coating, but sealant is really only necessary if the prop is going to see heavy weather exposure.
I've had cardboard fence columns for going on 3 years, and they've even been rained on, and still look pretty good.
Yes, TK421, I was planning on building layers of squared wood platforms on both the tops and bottoms of the pillars, then adding urns or lamps of some kind on top. I figure if I drill a few holes into the squared bases I can stake them into the ground with metal rods for support.
I am also considering attaching a skewed PVC "iron"gate to each pillar in a permanent open position as an added means of support.
Something else you can try is getting some of the 1/4" blue foam from Lowes and wrap it around the pillar. This will give you something you can carve and detail.
What a great link!!! Thanks for posting that, Terra. I know there are a lot of tutorials I haven't even seen yet, just sitting on pages from days gone by.
There called sonet tubes and you can use Dry-loc for the paintworks great for that and gives a stone look to it.also if you use any latex type paint and deside to seal it after make sure the sealant is ok for latex otherwise it will peel the latex off.
Sono Tubes generally have a waxy covering on the inisde of them so they can stand up pretty well to weather.
I used these for the columns on the exterior of my crypt . I painted the outside with latex exterior paint and sand mixture and they stood up to around 2 weeks in the weather outside with no visible damage.
Of course they were covered from the top and the bottom was not directly on the ground ( on steps )
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Halloween Forum
2M posts
83.4K members
Since 2002
Halloween forum - Keeping the Halloween spirit alive 365 days a year. Discuss decorations, costumes and more!