3 Visitor Messages

  1. View Conversation
    Paper Mache Make and take for AZ Haunters coming up July 17! Visit AZhaunters.ning.com for details! We'd love to see you there! Heck, we'd love to see you even if you don't want to do paper mache!
  2. That sounds pretty ingenious. I have had little time to play with Halloween stuff this year as I am getting married in about a week (I don't know why I though it was a good idea to get married this close to Halloween) but come new year I will be dusting off the 3 axis skull again and getting him ready to rock for next Halloween. If I need any help I will be sure to message you.

    Happy Haunting
  3. View Conversation
    slicerd, I was reading an old post of yours to halloweenjared and you were asking about hooking up leds to a controller. I am hooking Leds up to an ssc32 board (using the relay setting in VSA) and taking the signal pin through a 100 ohm resistor into the base of a small transistor. the emitter is connected to ground and the collector goes to the negative side of the led, the pos side goes through a resistor that is connected to +12Vdc. when VSA turns on the relay the signal pin from the ssc32 goes high (5vdc) and turns on the transistor which allows the CE juntion to conduct and turn on the LED. Just in case you hadn't already figured it out, I realize it was an old post. Keith
Showing Visitor Messages 1 to 3 of 3
About slicerd

Basic Information


Age
30
About slicerd
Location:
El Mirage AZ

Statistics


Total Posts
Total Posts
121
Posts Per Day
0.14
Visitor Messages
Total Messages
3
Most Recent Message
06-27-2011 02:47 PM
General Information
Last Activity
10-21-2011 12:12 AM
Join Date
08-27-2009
Referrals
0