Thread: D.I.Y. adjustable PVC elbow for statue frames

Tweet

This is a not so elegant, cost effective way to add different poses to your creations. Each joint typically costs under a $1.50 and only takes a few minutes to make.
I used a lot of these in the last statue I built.




You will need:
2 PVC straight pipe couplers
2 Serrated flange nuts. One size
larger (thread size) than the bolts you are using
2 carriage bolts and wing nuts

Hacksaw
Drill
Vise

I made some drawings and instructions in this tutorial:
http://creaturebuilders.com/tutorial..._pvc_joint.pdf

I hope you find this information useful.

Great idea, thanks for sharing. Keep up the good work.

Great idea...too bad I can't trust myself with a drill.