Thread: scence setter pictures

Tweet

I have a few of the scence setters pictures I use every year. After being folded and put away year after year they get wrinkles and lines that are hard to get by just tacking to the wall. So, I had an idea and it worked prettyngood. Take a sheet of thin foam board, the kinnd I used goes behind vinyle siding. cut to size or just a little larger than your picture and spray the craft glue on the foam, wait a minute or so and work the sheet down onto the foam. you have plenty of time to work out the air pockets and get it smooth. Afterwards you can cut around the edges and make even. You could use foam board for posters depending upon the size of your picture. Now they should last a right good while.

Great idea, thanks for sharing. I like the scene setters, but they hard to keep on the walls sometimes.

Yes, thank you. I got so frustrated with mine years ago; I wanted to put them on the outside of the garage door, and they just wouldn't stay. So, I wound up rolling duct tape and just slapping it in the corners and they still fell down after awhile. I just gave up, but didn't throw them out. However, the tape would not come off, and now the corners are all messed up, so I was wanting a way to cut the shapes out (tombstones, skellies, ghosts/ghouls), and do away with all of the clear parts. The ones I got were the creatures that go over the backgrounds, so most of the setter is actually clear. This should work great for them!