Thread: My Toe pincher fog chiller (Pic Heavy)

Tweet

here is my version of the coffin fog chiller I have not yet figured out what to do to the outside but it is functional . i figure it will take 150+ lbs of ice I am using 2 chauvet h-1100 foggers in it. as soon as i fill it with ice I will post a video
Special thanks to Rojellio he was one who inspired me to build a coffin fog chiller after seeing his videos of his chiller.

will there be a vid or pix of it in action? btw it looks great

It looks good so far. However... I am not sure how well its going to flow. on the trip all the way back to the head end, much of the fog will leak out the lid edge.

Personally, I would go with two separate chicken wire tubes about 2' shorter than the one you have. Then position a tube in front of each fogger. Run them side by side with an equal gap between the sidewalls and between each tube. The cross section looking kind of like this. [ O O ] Notch 2 holes into the mid cross brace, to hold the tubes in position in front of the fog nozzle. Then run each tub from the fogger, to the head end, bend down and go back out the toe side.

Lookin good Spook! Glad to see you back in action brother!!!!!

yes I will be posting a video soon.
as for the leakage I am going to be using rubber weather striping all around the edges and the lid will be bolt on not hinged so there should be zero leakage when I am finished.
Thanks meyers been realy busy lately so i am trying to play catch up halloween getting all my props ready.