Thread: Lost my VSA Registration Code!!!

Tweet

Well, 2.5 years ago I start building my 3-Axis skull. I finished it, tested it, it worked great with the VSA Demo Software. If memory serves, they were running a short special on the software (possibly a group buy for us here?), and I bought a copy. I downloaded the install file, but never installed it. I ran out of time to program the 3-axis completely, and implement it into my display.

Since then, the skull has taken back seat to MANY other props- until now. I just installed the software, but CANNOT FOR THE LIFE OF ME find my registration code! I think it was on my old laptop, which crashed and died on me last year. I've searched everywhere, but no luck.

Any thoughts/input?

I am contacting Brookshire now, hopefully they can check their records and see I purchased it previously....

I had a similar issue where I changed computers and needed to re-install. I contacted Brookshire and was given new codes without a problem.

We had to email Brookshire for our code as well after a computer crash. They grumbled a bit but gave it to us again.

MsM

Got a new code no problem when I had computer problems also.

ok cool. Hopefully they'll respond. My concern is that I bought this nearly 3 years ago- an older version of the software. Hopefully they can help!

You should consider getting the latest version. There have been lots of improvements to the software int he last three years.

Dang... unfortunately, it's just not in the budget to buy new software. I wish I could tho!