Thread: Motion Control for 3-Axis Skull

Tweet

Hey Guys I just finally got around to ordering my Bucky's for my 3-axis skulls. Now what I wanted to do it have my routine kicked off by motion. So that way my greeter isn't running when no one is around. I'm not really sure how to incorporate this in. Can anyone help me out and explain a little more on how I would hook up a motion sensor to my 3-axis setup? I'm using the GYM ghost setup with the Lynx board to control my servos.

Thanks!

your using vsa to run them correct? if so the routine is triggered by the enter key of a keyboard, first you have to get a motion sensor, you need to make a dry contact closure ( like a switch ) so you will need ether a motion sensor from an outdoor light and a relay to convert the 120v to a contact closure, or a motion sensor that has all of this built in like this one FrightProps - Halloween Props, Pneumatic Props, Animated Props, Halloween Accessories

you then can ether wire it to the enter key on a key board or get a key board emulator like this one KeyWiz Max 1.5 [KWS00015] - $34.95 : GroovyGameGear.com, Always the best in Arcade, Jukebox, Kiosk, Gaming and Industrial controls