Thread: Anyone know how?

Tweet

Does anyone know how to make a inexpensive eye slide that will work off of 1 servo? and have Video of it working?Thanks ahead of time. or a link to a good set up?

Am I understanding you right?Are you looking for a setup to have 2 eyes move up and down on 1 servo?

If i understand you right look at this.Way at the bottom.
http://www.calhaunts.com/downloads/3_axis_skull.pdf

well you could use a rod going through the eye to connect it to the skull and then have a rod coming out of the back of each eye, then attach a cross bar to the bars coming out of the eyes. place the servo above or below the cross bar so that when the servo pulls/pushes the bar up the eyes go down and when it pulls/pushes the bar down the eyes go up. i am working on two axis eyes right now that will use too servos, one for up/down one for left/right. i will post pics of my progress but it will be a about 2 weeks for the 2-axis eyes however i can probably post a vid of a one axis setup later that might be what your looking for

yes skullboy but side to side Thank you for your help too guitarist. I thought I saw one in this forum but when I went to look for it I cant find it

it appears wicc-ed had the same concept for the 1 axis eyes that eye did

Originally Posted by guitarist155

it appears wicc-ed had the same concept for the 1 axis eyes that eye did

Yes I See lol but not every well lol

I have My eye slide made Thank you All for giving me ideas.

I wish I had a camera to take a pic of it. Sorry!!

and a Big Hug To Wicc_ed for inspiration