Thread: RGB LED Color Mixing

Tweet

Anyone know of a good board/kit/design that would run and change the colors of RGB LED's off of a servo connection on a parallax board, or even the lynxmotion board? This is the only thing I could find that would be kinda close except the baud rate is all off http://images.google.com/imgres?imgu...en-US%26sa%3DN
And Im cool with soldering, as long it isnt micro soldering...
Thanks, Mike

This is exactly what the Skulltronix BoC does, as well as having 16 servo channels it comes with an RGB LED port

Our rev 1 ,2 and 3 skulls used small circuit boards in the eyes that had a cypress processor, voltage regulator, resistors and the rgb led. The CPU interpreted serial commands on the parallax board to set color and brightness.
We may have a few still available but they aren't cheap.. $35 ea.
If you want a large qty let me know.
The Board of Chuckee has the led circuitry built in.
916 600-2295
Jerry

Any other options out there?

None to scant few, I know this because its something I researched myself and it was for this very reason that I originally contacted Jerry.

$35 for a RGB controller off servo commands sounds like a good deal to me. RGB controllers in general are expensive. Out of curiosity, what's the maximum power handling of your controller Jerry? Would it handle (or be modified to handle) 3, 1 watt, LEDs?

i found this at this web site i was woundering if this would work ........ http://www.zzounds.com/item--CHVLEDPAR83

thanks, whats the pricing on that... I was hoping to spend 50 or less on the controller... and would it work for VSA?

Originally Posted by evileyes

i found this at this web site i was woundering if this would work ........ http://www.zzounds.com/item--CHVLEDPAR83

unless your skull is 10' high then you may find these lights a little big for eyes

ok... pricings not too bad... the only problem is I need VSA to activate Vixen... not vixen to activate VSA because Im using an Exorcist... hmmmm....