Exorist Prop

**madmax** · 07-30-2005,11:09 PM

I started my Exorcist Prop Sat morning and finally got it close to being finished. When I set out to build this prop it was going to be totally different than it ended up. She was going to be laying on the bed and levitate straight up almost 4 feet then sit up and start puking. After hours and hours of not being able to work out the weight problem I was having with a 5 foot frame. I changed the workings of this prop.

Now she's kneeling on her bed (well she will be when I place her in her room) hugging the wall, at the foot of the bed. when activated she climbs the wall (her head actually touchs the ceiling) then she leans back and starts puking.....Of course it will be pea green puke. I still need to add hand, feet and the pump. Here's a very bad picture of her climbing the wall. The link below that will take you to a clearer short video of her in action.

Link to video
http://www.hauntpics.com/gallery/dis...t=10079&pos=13

**vexedly** · 07-30-2005,11:56 PM

That is just awesome! Does she have a face yet ? I would love to see it.
I'm just a newbie so bare with me =).
How is she held up?
What kind of motor did you use?
I love the climbing up the wall thing - to be honest, I watched your clip
for a good 10 minutes straight in awe.
Job well done!
Let me tell you, if I was stuck in a room all alone with her, lord knows what I'll do.
Just awesome. Speachless.
=)

**madmax** · 07-31-2005,12:43 AM

Vexedly, this prop uses 2 air cylinders.....no motors. She's connected to a rodless cylinder that will be embedded into the wall. She has a face, well half a face, one side is corsped. You just can't see it in the picture. When I built this I wasn't sure about what type of head/face I was going to use. So I built her with a pop off head. I'm thinking about changing the head to more human like, if I have time.